If you’re like most people, you probably don’t have a lot of experience putting Christmas lights on a car. But with a little bit of preparation and some helpful tips, it’s not too hard. Here are four steps to help you get started:

  1. Decide where you want to put the lights. You can put them on the roof or the sides of the car, but be sure to choose a spot that’s safe and won’t block your view.
  2. Get your supplies. You’ll need some Christmas lights, wire cutters, and an electric drill.
  3. Cut the wires off the Christmas lights. Make sure that each light has two wires - one red and one green - so that you can connect them together later on.
  4. Drill holes in the side of your car where you want the lights to go. Make sure that they’re big enough so that the wires can fit through without getting tangled up in each other or in any sharp edges on the car surface. Then thread each wire through one hole and tie it off securely with a knot (or use electrical tape). Repeat this process for all of your lights ..

title: “How To Put Christmas Lights On A Car” ShowToc: true date: “2022-11-01” author: “Joseph Belknap”

If you’re like most people, you probably don’t have a lot of experience putting Christmas lights on a car. But with a little bit of preparation and some helpful tips, it’s not too hard. Here are four steps to help you get started:

  1. Decide where you want to put the lights. You can put them on the roof or the sides of the car, but be sure to choose a spot that’s safe and won’t block your view.
  2. Get your supplies. You’ll need some Christmas lights, wire cutters, and an electric drill.
  3. Cut the wires off the Christmas lights. Make sure that each light has two wires - one red and one green - so that you can connect them together later on.
  4. Drill holes in the side of your car where you want the lights to go. Make sure that they’re big enough so that the wires can fit through without getting tangled up in each other or in any sharp edges on the car surface. Then thread each wire through one hole and tie it off securely with a knot (or use electrical tape). Repeat this process for all of your lights ..